Mini -FILBE pack in 500D Cordura

Sewed up a Mini-FILBE (Family of Improved Load Bearing Equipment) Pack in 500D Cordura, Coyote Brown, Flame Resistant coated; using USGI webbing and hardware. The pack is a simple packbag, just one large compartment, no lid pocket, and covered in MOLLE and ALICE webbing.

Specs

19x12x9″, approximately 2,052 cubic inches

7 rows of MOLLE on main bag body

2 rows of ALICE on main bag body

3 rows of MOLLE on lid and bottom

Drawcord closure with flat black grommets and OD stripped paracord

Duraflex buckles from National Molding in Coyote Brown

ITW-Nexus Coyote Brown 1″ D rings; 1.5″ black D rings

ITW Nexus LadderLoc buckles

Black Oxide Tri-bar tabs for frame attachment and compression strap attachments

DSCF2511

Main pack in slick mode

DSCF2510

side of pack showing compression strap

DSCF2518

frame and suspension side

DSCF2517

Showing how side compression strap attaches to frame side horn via black tri-bar buckle

DSCF2512

bottom of pack showing MOLLE for additional lash points or pouches

DSCF2513

with frame and suspension removed. Pack can be used frameless via the 4 D-rings, using ALICE shoulder straps or similar straps available from Fireforce USA and Tactical Tailor

DSCF2514

Upper corner frame attachment point with black tri-bar buckle

DSCF2507

Detail of where the black tri-bar attaches on the frame upper corners behind the shoulder yoke assembly

DSCF2515

Lower frame attachment strap with D ring for frameless carriage

DSCF2506

Detail of how the upper 1.5″ D-rings interface with the load stabilizer buckles on the shoulder yoke assembly. I might add more webbing to stabilize the D-rings in those location to prevent twisting.

DSCF2516

Showing the interior. It is one layer of 500D fabric where the white side is the Flame Resistant coating, and double layer on the back/frame panel. Also you can see how I attached the paracord to the corners for drawcord closure.

DSCF2509

Detail shot of drawcord closure with OD paracord, 0.5″ hole diameter grommets, and USMC surplus duraflex chest rig webbing mount buckles for side compression straps

 

DSCF2505

Shot of pack with 2x USMC IFAK pouches, 2x SDS canteen pouches attached

DSCF2508

Side view of pouches on the pack, showing how close the webbing and fabrics are in colors.

DSCF2504

Comparison shot of Mini-FILBE next to Propper made USMC FILBE pack; yes the USMC pack is HUGE compared to the Mini-FILBE.

DSCF2501

DSCF2499

Two shots of FILBE, Large ALICE, and Mini-FILBE packs; the Mini FILBE with pouches seems quite similar in size to Large ALICE, but is shorter in height.

DSCF2502

USMC FILBE next to Large ALICE rucksack. The FILBE is again, much larger than the Large ALICE rucksack.

DSCF2519

Stuffed the FILBE bag as much as I could to better show the size differences

DSCF2520

another view of size differences

DSCF2521

Also stuffed the Large ALICE ruck, again to show differences.

DSCF2522

Side profile shots of the three bags

DSCF2523

Lid size comparison; in these photos, none have frame and suspensions on, to better show the relative sizes.

I do not have an example of a Medium ALICE rucksack to compare against the Mini-FILBE; but I have a hunch it is just a teeny bit smaller.